Vertex Standard VX-231 Bedienungsanleitung PDF herunterladen

OperatiOn

Preliminary StePS



 Install a chargedbatterypack ontothetransceiver, as de-

scribedpreviously.



 Screw the supplied antenna ontotheAntenna jack. Never

attempt to operate this transceiverwithoutan antenna con-

nected.



 IfyouhaveaSpeaker/Microphone,werecommendthatitnot

beconnecteduntilyou arefamiliar withthe basicoperation

ofthe

VX-230

OPeratiOn Quick Start



 Turnthetoppanel’s

VOL/PWR

knob

clockwisetoturnontheradioon.



 Turnthetoppanel’s

selectorknob

to choose the desired operating chan-

nel.



 Rotatethe

VOL/PWR

knobtosetthe

volume level. If no signalis present,

pressandholdinthe

Programmable



keyassignedto“SQL OFF”formore

than one second; backgroundnoise

willnow beheard, and youmayuse

thistosetthe

VOL/PWR

knobforthe

desiredaudiolevel.

BefOre YOu Begin

Battery Pack inStallatiOn and remOval



 To install the battery, holdthe transceiverwith your lefthand,

soyourpalmisoverthespeakerandyour

thumbisonthetopofthebeltclip.Insert

the battery pack intothe battery

compartmentonthebackofthe

radio whiletilting theBelt

Clipoutward, then push

thebottomside of the

battery pack until

t h e b a t t e r y p a c k

locks withthe Bat-

teryPackLatch.



 Toremovethebattery,turntheradiooffandremoveanyprotec-

tive cases. Slide the Battery Pack Latchon thebottomof the

radio,thenslidethe battery downward andout fromthe radio

whileholdingtheBeltClip.

Caution

Do not attempt to open any of the rechargeable Lithium-

Ion packs, as they could explode if accidentally short-

circuited.

lOw Battery indicatiOn

Asthebatterydischargesduringuse,thevoltagegraduallybecomes

lower.Whenthebatteryvoltagebecomestolow,substituteafreshly

charged battery and rechargethe depleted pack.When the battery

voltageislow,theLEDindicatoronthetopoftheradiowillblink

red.Furthermore,ifyourDealersetsthe“LowBatteryAlert”feature

intothetransceiver,analertbeeperwillsoundwhenthebatteryvolt-

ageislow.



 Pressandholdinthe

Programmable



keyassignedto“SQL OFF”formore

than one second (or press the key

twice) to quiet the noise and resume

normal(quiet)monitoring.



 Totransmit,monitorthechannelandmakesureitisclear.



THIS IS AN FCC REQUIREMENT!



 Totransmit,pressandholdinthe

PTT



switch.Speak into the microphone

areaof the frontpanel grille (lower

right-handcorner)in a normalvoice

level.To return to the Receive mode,

releasethe

PTT

switch.

 Do not transmit the radio without

an antenna connected.



 IfaSpeaker/Microphoneisavailable,removetheplasticcapand

its twomounting screws from the right side of the transceiver,

theninserttheplugfromtheSpeaker/Microphoneintothe

MIC/

 jack;securethe plugusing the screwssupplied with the

Speaker/Microphone.Holdthespeakergrilleupnexttoyourear

whilereceiving.Totransmit,pressthe

PTT

switchontheSpeak-

er/Microphone,justasyouwouldonthemaintransceiver’sbody.

Note: Save the originalplastic cap and its mounting

screws.Theyshouldbere-installedwhennotusingthe

Speaker/Microphone.

Microphone

Speaker

MIC/SP Jack

(

ExternalMic/Earphone

)

VOL/PWR Knob

(

Channel

)

Selector

Side 1 Switch

Push To Talk

(

PTT

)

Switch

Antenna

LED Indicator

Battery Pack Latch

Side 2 Switch

Vertex Standard LMR, Inc.

SafetY training infOrmatiOn

ThisRadiohasbeentestedandcomplieswiththeFederalCommu-

nications Commission (FCC)RF exposure limitsfor Occupational

Use/Controlledexposureenvironment.Inaddition,itcomplieswith

thefollowingStandardsandGuidelines:



 FCC 96-326,Guidelines for Evaluating theEnvironmental Ef-

fectsofRadio-FrequencyRadiation.



 FCCOETBulletin65Edition97-01(1997)SupplementC,Eval-

uatingCompliancewithFCCGuidelinesforHumanExposureto

RadioFrequencyElectromagneticFields.



 ANSI/IEEEC95.1-1992,IEEEStandardforSafetyLevelswith

Respect to Human Exposure to Radio Frequency Electromag-

neticFields,3kHzto300GHz.



 ANSI/IEEE C95.3-1992, IEEERecommendedPractice for the

Measurement of Potentially Hazardous Electromagnetic Fields-

RFandMicrowave.

WARNING:ThisradiogeneratesRFelectromagneticenergy

duringtransmitmode.Thisradioisdesignedforandclassi-

edasOccupational Use Only,meaningitmustbeusedonlyduring

thecourseofemploymentbyindividualsawareofthehazards,and

thewaystominimizesuchhazards.Thisradioisnotintendedforuse

bytheGeneral Populationinanuncontrolledenvironment.

CAUTION:ToensurethatyourexposetoRFelectromagnet-

icenergyiswithintheFCCallowablelimitsforoccupational

use,alwaysadheretothefollowingguidelines:



 Please read this manual carefully to become familiar with the

features of this transceiver.



Do not transmit the radio without an antenna connected.



 This radio is NOT approved for use by the general popula-

tion in an uncontrolled environment. This radio is restricted

to occupational use, work related operations only where the

radio operator must have the knowledge to control its RF ex-

posure conditions.



 When transmitting, hold the radio in a vertical position with

its microphone 1 to 2 inches (2.5 to 5 cm) away from your

mouth and keep the antenna at least 1 inch (2.5cm) away

from your head and body.



 The radio must be used with a maximum operating duty

cycle not exceeding 50 %, in typical Push-to-Talk (PTT) con-

gurations. DO NOT transmit for more than 50 % of total

radio use time (50 % duty cycle). Transmitting more than 50

% of the time can cause FCC RF exposure compliance re-

quirements to be exceeded.

To keep the Body Worn conguration with the Vertex Stan-

dard CLIP-18 belt-clip, reduce the maximum operating duty

cycle still more.

The radio is transmitting when the red LED on the top of

the radio is illuminated. You can cause the radio to transmit

by pressing the PTT button or by using the Vertex Standard

VC-25 VOX headset.



 When operate the radio with the Vertex Standard CLIP-18

belt-clip, make the transmission time as short as possible, to

keep the Body Worn conguration.



 Always use the FNB-V103LIA or FNB-V104LIA Lithium-Ion

Battery.



Risk of explosion if battery is replaced by an incorrect type.

Dispose of used batteries according to the instructions.



Perform the battery charging where the ambient tempera-

ture range +50 °F to +104 °F (10 °C to +40 °C). Charge out

of this range could cause damage to the battery pack.



Battery Pack shall not be exposed to excessive heat such as

sunshine, re or the like.

Vertex Standard LMR, Inc.



Always use Vertex Standard authorized accessories.

Vertex Standard shall not be liable for any damage or ac-

cidents such as fire, leakage or explosion of batteries, etc.,

caused by the malfunction of non-Vertex Standard accesso-

ries.



This radio generates RF electromagnetic energy during

transmit mode. This radio is designed for and classified as

occupational use only, meaning it must be used only during

the course of employment by individuals aware of hazard-

ous, and the ways to minimize such hazardous. This radio is

not intended for use by the General Population in an uncon-

trolled environment.

Theinformationlistedaboveprovidestheuserwiththeinformation

neededtomakehimorherawareofRFexposure,andwhattodoto

assurethatthis radio operates withtheFCC RF exposure limitsof

thisradio.

Electromagnetic Interference/Compatibility

During transmissions, this radio generates RF energy that can

possibly cause interference with other devices or systems. To

avoid such interference, turn off the radio in areas where signs

are posted to do so.

Do not operate the transmitter in areas that are sensitive to elec-

tromagnetic radiation such as hospitals, health care facilities,

aircraft, and blasting sites.

FCC LICENSE INFORMATION

This radio operates on communications frequencies which are

subject to FCC (Federal Communications Commission) Rules

and Regulations. FCC Rules require that all operators using Pri-

vate Land Mobile radio frequencies obtain a radio license before

operating their equipment.

acceSSOrieS & OptiOnS

FNB-V103LIA

 7.4V1380mAhLithium-IonBattery

FNB-V104LIA

 7.4V2300mAhLithium-IonBattery

VAC-300

 DesktopRapidCharger(CD-34+PA-42)

VAC-6300

 6-unitMultiCharger

PA-42

 ACAdapter(forCD-34)

MH-37

A4B

 Earpiece/Microphone

MH-45

B4B

 Speaker/Microphone(NoiseCancelling)

MH-360S

 Speaker/Microphone(SmallType)

MH-450S

 Speaker/Microphone(MiniatureType)

VH-115S

 Lightweightheadsetw/Boommic

VH-215S

 Lightweightpaddedheadset,SingleSpeaker

VH-225S

 Lightweightpaddedheadset,DualSpeaker

VC-25

 VOXHeadset

VCM-2

 VehicleChargerMountAdapter

DCM-1

 DesktopChargerBracket

ATV-8A

 RubberAntenna134-151MHz

ATV-8B

 RubberAntenna150-163MHz

ATV-8C

 RubberAntenna161-174MHz

ATV-6XL

 RubberAntenna134-174MHz(Untuned)

ATU-6A

 RubberAntenna400-430MHz

ATU-6B

 RubberAntenna420-450MHz

ATU-6C

 RubberAntenna440-470MHz

ATU-6D

 RubberAntenna450-485MHz

ATU-6F

 RubberAntenna485-520MHz

CLIP-18

 BeltClip

LCC-230

 LeatherCase

CE99

 ProgrammingSoftware

FIF-12

 USBProgrammingInterface

CT-27

 RadiotoRadioProgrammingCable

CT-42A

 PCProgrammingCable(CT-29+CT-28)

CT-106

 PCProgrammingCable(forFIF-12)

Tilt the Belt Clip

Insert the Battery Pack

Push the bottom side

of the Battery Pack

vX-230 SerieS

OPerating manual

cOntrOlS & cOnnectOrS

Green Monitoron(orSide1orSide2switchisactivated)

Blinking Green BusyChannel(orSQLoff)

Glows Red Transmitting

Blinking Red BatteryVoltageisLow

Yellow ReceivingaSelectiveCall

Operating temperature range

(

FOr eurOpean user

)

Operation:–20°Cto+55°C

Battery Charging:+10°Cto+40°C

(Turntheradiooffwhilechargingthebattery)

1 2

OPerating manual 1
KeY functiOnS 2

Inhaltsverzeichnis

Seite 1 - OPerating manual

OperatiOnPreliminary StePS Install a chargedbatterypack ontothetransceiver, as de-scribedpreviously. Screw the supplied antenna onto

Seite 2 - KeY functiOnS

mOn (mOnitOr)Press(orPressandhold)theassignedPFkeymomentarilytodis-abletheTone squelch.When disablestheTone squelch,the LEDindic

Kommentare zu diesen Handbüchern

Keine Kommentare

Vertex Standard VX-231 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Funkgeräte Vertex Standard VX-231 herunter. VX-231 Series Owner`s Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Funkgeräte Vertex Standard VX-231